E-Tech ET8 Dokumentacja Pobierz pdf (Strona 326)

100

101

292 IBM BladeCenter JS23 and JS43 Implementation Guide

connect icon. Once the session starts the connection the partition can be

activated. Partition activation is discussed in the next section.

Figure 7-47 Connect console session

7.3.7 IBM i 6.1 IPL types

The IPL type determines which copy of programs your system uses during the

initial program load (IPL).

IPL type A Use IPL type A when directed for special work, such as

applying fixes (PTFs) and diagnostic work.

IPL type B Use the B copy of Licensed Internal Code during and after

the IPL. This copy resides in System Storage Area B. This

copy contains temporarily applied fixes.

IPL type C Development support reserves this type of IPL for

hardware service representatives.

Note: Do

not use this function. Data loss can occur with

improper use of this function.

IPL type D Use IPL type D when directed for special work, such as

installing and reloading programs. IPL type D loads the

system programs from an alternate IPL load source, such

as a tape drive or CD-ROM.

Typically, an IPL uses programs that are stored on the

primary IPL load source (typically a disk drive). However,

sometimes it is necessary to perform an IPL from another

source, such as programs that are stored on tape. To do

this, you must use IPL type D to perform an IPL from the

alternate IPL load source.

When configuring the IBM i 6.1 partition, use IPL Type D to install and set up the

environment. After the Licensed Internal Code (LIC) is successfully installed, the

installation process will automatically change the IPL type to A.

1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 617 618

Komentarze do niniejszej Instrukcji

Brak uwag

E-Tech ET8 Dokumentacja Strona 326

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa E-Tech ET8